Finishing Touch Flawless Nu Razor Hair Remover (2023)

Selected quantity exceeds what is currently available

Send this product to a friend

$16.49

• Use on clean, dry skin.
• No water, soap or creams should be used.
• Prior to first use test on small, discreet area and wait 10 minutes.
• If sensitivity or allergic reactions occur, discontinue use immediately.
• Use the optional SensaGuard cover for sensitive areas.
• As with all razors/shavers, use with caution.

USING NU RAZOR

• Before first use, fully charge the unit.
• Use on clean, dry skin. No water, soap or creams should be used.
• On sensitive areas like under arms and bikini area, use the SensaGuard attachment.
• Glide lightly over dry skin. Pressing hard may reduce cutting performance and cause irritation.
• Shave back and forth.

SENSAGUARD - USE ON SENSITIVE AREAS

• Align the tabs on the SensaGuard attachment to the tabs on the head of the Flawless Nu Razor™ device.
• Press onto the head until you hear it click into place.
• Use the SensaGuard attachment for sensitive areas like under the arms and the bikini area.
• To remove, place your thumb on the center of the head while lifting the corner of the SensaGuard attachment and releasing it from the head.
• NOTE: Some areas can be sensitive. Please use the SensaGuard attachment and be gentle.

CHARGING / RECHARGING

• Make sure the unit is turned off.
• Insert charging cable as shown. Insert USB end into USB compliant power adapter.
• Only use with charging cable provided.
• The LED light will flash while charging.
• Once the unit is completely charged, the light will become solid and will stop flashing.
• Remove charging cable from power adapter, then from the unit.
• Approximate charging time is 3 hours.
• NOTE: The unit won’t operate while charging.

OPERATING TIME

• The unit has an operating time of approximately 60 minutes.
• If the unit begins to slow down, clean the head. If still slow, charge unit.

REMOVE AND REPLACE HEAD

• Remove any attachments.
• Place your thumb at the base of the head and press upward while holding the sides of the head to prevent falling.
• Hold the new head by its sides and press onto the neck of unit.
• There will be a “click” when the head is secure.
• NOTE: The Replacement Head is not included.

CARE AND MAINTENANCE

• Never use harsh liquids such as alcohol, acetone or nail polish remover to clean the unit.
• Clean the unit after every use.
• To clean, turn the unit off. Remove the SensaGuard if still attached to the head.
• Blow off any hair and debris which remain after use. DO NOT tap the cutting head on a hard surface, as it may cause damage.
• Switch the unit on and run only the shaving head under lukewarm water for approximately 10 seconds. Do not full submerge head in water.
• Turn the unit off and carefully shake off the excess water. Set unit aside and allow to air dry completely.
• Store unit and accessories in a dry, safe place.
• NOTE: • The Finishing Touch Flawless Nu Razor™ head is precision crafted and can be dam- aged if you drop, or bang it. Care should be taken during use and cleaning. Always check the unit for damage before each use.
• Replace a damaged shaving head immediately.
• This product has no other user-serviceable parts. Contact Flawless Customer Service for further assistance.

• Before first use, fully charge the unit.
• Use on clean, dry skin. No water, soap or creams should be used.
• On sensitive areas like under arms and bikini area, use the SensaGuard attachment.
• Glide lightly over dry skin.
• Pressing hard may reduce cutting performance and cause irritation.
• Shave back and forth.